The blueprint is created because the Netatmo to WUnderground upload isn’t working (it’s possible in the WUnderground ‘add station’ wizard, but fails). This service needs to be enabled with, for example, the following YAML. This blueprint needs to execute a shell_command. WUnderground pulled a free service down, but I support the idea of a community based weather station. The WUnderground data upload for weather stations is based on a GET request, so it is possible to achieve these results within an automation. Wait for approximately 10 minutes and verify the address change was received by WU.A blueprint to upload Home Assistant sensor data to WUnderground. Go to Settings > Devices > Select the Connection Device shared with WU > Make a change to the address. The change initiates a connection from My AcuRite to WU. If the reading data is still not available, verify Weather Underground is receiving My AcuRite data updates by changing the location address of the Connection Device.Please wait up to 1 hour for your reading data to be available in WU. If your profile is set up correctly, remove and re-enter your Weather Underground profile in My AcuRite.It is now a separate key (Station Key) that is generated specifically for each Weather Underground station ID. The password for your weather station is no longer the same as the password for your account. The Weather Underground Station Key is case sensitive and does not allow special characters. We recommended not to copy and paste your Password (Station Key). If you have an "O" or "I" as the last letter before the number(s), it's very easy to mistake it as a number.
Be sure to enter the Station ID exactly as it's displayed in your Weather Underground account - in all capital letters and is almost always comprised of eight letters and one to three numbers.
0 kommentar(er)
